If you use OV9281, IMX290, IMX378, or non-Raspberry Pi official IMX219 and IMX477 cameras, you need to configure the config.txt file separately.įind "camera-auto-detect=1" and modify it to "camera_auto_detect=0"Īt the end of the file, add the following setting statements according to the camera model.ĭtoverlay=imx290,clock-frequency=37125000 Select Interface Options -> Camera -> Yes -> Finish -> Yes Open the Raspberry Pi terminal and use the command to enter the setting interface.If you are using the latest bullseye image, the camera interface has been enabled by default, so you can skip the modification steps. This product does not support other Raspberry Pi boards.Ībout the model Photosensitive chip model If you are using a computing module, the specific layout of the backplane shall prevail.Ĭonnect the metal side of the cable to the camera interface.ĭirect the metal side of the cable to the HDMI port and connect it to the camera port. The CSI interface is between the audio interface and the HDMI interface, and the camera interface of the Raspberry Pi Zero series is next to the Power interface. The packages of the CSI (camera) and DSI (display) interfaces on the Raspberry Pi board are similar, so be careful not to connect them wrongly when wiring. To test the Raspberry Pi camera, you need to connect an HDMI screen or a DSI screen to the Raspberry Pi. 7.8 Video Recording Image Setting Parameters.
7.7 Still Photo Shooting Setting Parameters.
0 kommentar(er)
